How To Install Bamboo Fencing On Colorbond
HOW TO INSTALL TO COLORBOND Fence
Notation:If you don't have admission to the bottom rail because it is beneath ground level, below decking level, backside a retaining wall or below ground level etc… you lot will demand to insert a timber betwixt the posts (i.e. decking board). Insert the timber or decking board horizontally between the vertical posts as low every bit you tin can. A decking board will fit snug inside the vertical section on either side of the colorbond panel. You won't demand to screw it in.
- Place the bamboo console in position on the colorbond fence.
- Choose a corner at the tiptop of the bamboo panel and drill a hole through the bamboo stick and into the frame of the colorbond debate (this is the thick horizontal section of your colorbond fence. Make sure the drill fleck you are using is smaller in thickness than your screws).
- Insert a spiral. You can use wood or chipboard screws equally this has been pre drilled. If yous are near the declension you lot may want to use rust proof or stainless steel screws. Use screws approx 57-65mm in length depending on the thickness of the bamboo. Utilize the standard Phillips head screws equally these are the to the lowest degree noticeable.
- Now drill a pigsty and insert a screw at the opposite summit corner of the console and insert a screw.
- Now do the same at the lesser of the console. (optional, you lot can as well insert screws in the center (top and lesser) of the panel)
- Place the next panel adjacent to the installed panel and repeat above process.
Cut the Bamboo
If you need to cut the bamboo use a Metal Cutting Disc on an angle grinder, the aforementioned as you lot would use to cutting steel. A circular saw tends to shred the bamboo. You can also employ a manus saw.
Source: https://cavemanbamboo.com.au/how-to-install-to-colorbond-fence/
Posted by: erbeprisperfes.blogspot.com
0 Response to "How To Install Bamboo Fencing On Colorbond"
Post a Comment